-
LOL that was nice @ Snowhog
HAPPY Birthday GG and wishing you many more !!
VINNYLeave a comment:
-
Well then, Happy Birthday!! And so, https://m.youtube.com/watch?v=xxOviBI-8fcLeave a comment:
-
Fairwell HD, I knew thee well!
Yesterday, while playing Minecraft full screen, my computer suddenly rebooted! As I watched the boot lines scroll by I noticed a brtfs error correction event. That led to a brtfs scrub which recovered two sector unreadable errors. Then came the smartctl short test, which showed:
which showed that eight of the 25 tests were "pre-failure" and the rest were old age. This laptop was purchased in 2010. I boot it up about eight out of every ten days and leave it on until I shut it down at night. The "start-stop" count corresponds to 5.2 years of ons and offs.Code:smartctl 6.5 2016-01-24 r4214 [x86_64-linux-4.4.0-34-generic] (local build) Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Toshiba 2.5" HDD MK..59GSXP (AF) Device Model: TOSHIBA MK6459GSXP Serial Number: 7162F6U4S LU WWN Device Id: 5 000039 3668014e2 Firmware Version: GN003J User Capacity: 640,135,028,736 bytes [640 GB] Sector Sizes: 512 bytes logical, 4096 bytes physical Rotation Rate: 5400 rpm Form Factor: 2.5 inches Device is: In smartctl database [for details use: -P show] ATA Version is: ATA8-ACS (minor revision not indicated) SATA Version is: SATA 2.6, 3.0 Gb/s (current: 3.0 Gb/s) Local Time is: Sun Aug 7 23:44:51 2016 CDT SMART support is: Available - device has SMART capability. SMART support is: Enabled === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED General SMART Values: Offline data collection status: (0x00) Offline data collection activity was never started. Auto Offline Data Collection: Disabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 120) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. General Purpose Logging supported. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 203) minutes. SCT capabilities: (0x003d) SCT Status supported. SCT Error Recovery Control supported. SCT Feature Control supported. SCT Data Table supported. SMART Attributes Data Structure revision number: 16 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0 2 Throughput_Performance 0x0005 100 100 050 Pre-fail Offline - 0 3 Spin_Up_Time 0x0027 100 100 001 Pre-fail Always - 1610 4 Start_Stop_Count 0x0032 100 100 000 Old_age Always - 1898 5 Reallocated_Sector_Ct 0x0033 100 100 050 Pre-fail Always - 24 7 Seek_Error_Rate 0x000b 100 100 050 Pre-fail Always - 0 8 Seek_Time_Performance 0x0005 100 100 050 Pre-fail Offline - 0 9 Power_On_Hours 0x0032 072 072 000 Old_age Always - 11206 10 Spin_Retry_Count 0x0033 137 100 030 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 100 100 000 Old_age Always - 1665 191 G-Sense_Error_Rate 0x0032 100 100 000 Old_age Always - 103 192 Power-Off_Retract_Count 0x0032 100 100 000 Old_age Always - 67 193 Load_Cycle_Count 0x0032 098 098 000 Old_age Always - 28783 194 Temperature_Celsius 0x0022 100 100 000 Old_age Always - 40 (Min/Max 12/46) 196 Reallocated_Event_Count 0x0032 100 100 000 Old_age Always - 3 197 Current_Pending_Sector 0x0032 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0030 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x0032 200 200 000 Old_age Always - 0 220 Disk_Shift 0x0002 100 100 000 Old_age Always - 73 222 Loaded_Hours 0x0032 076 076 000 Old_age Always - 9779 223 Load_Retry_Count 0x0032 100 100 000 Old_age Always - 0 224 Load_Friction 0x0022 100 100 000 Old_age Always - 0 226 Load-in_Time 0x0026 100 100 000 Old_age Always - 333 240 Head_Flying_Hours 0x0001 100 100 001 Pre-fail Offline - 0 SMART Error Log Version: 1 ATA Error Count: 2 CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 2 occurred at disk power-on lifetime: 11205 hours (466 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 41 d2 e0 45 8a 66 Error: UNC at LBA = 0x068a45e0 = 109725152 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 08 d0 e0 45 8a 40 00 00:30:07.139 READ FPDMA QUEUED 60 08 c8 d8 45 8a 40 00 00:30:07.139 READ FPDMA QUEUED 60 08 c0 d0 45 8a 40 00 00:30:07.139 READ FPDMA QUEUED 60 08 b8 c8 45 8a 40 00 00:30:07.139 READ FPDMA QUEUED 60 08 b0 c0 45 8a 40 00 00:30:07.138 READ FPDMA QUEUED Error 1 occurred at disk power-on lifetime: 11205 hours (466 days + 21 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 41 92 e0 45 8a 66 Error: UNC at LBA = 0x068a45e0 = 109725152 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- 60 40 90 00 45 8a 40 00 00:29:55.460 READ FPDMA QUEUED 60 80 88 60 43 8a 40 00 00:29:55.458 READ FPDMA QUEUED 60 40 80 00 43 8a 40 00 00:29:55.457 READ FPDMA QUEUED 60 a0 78 40 42 8a 40 00 00:29:55.457 READ FPDMA QUEUED 60 60 70 c0 3f 8a 40 00 00:29:55.451 READ FPDMA QUEUED SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 11206 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay.
I'm starting the long test (the GSmartControl app is neat!) and then taking my grandson Bass fishing. Today is my 75th birthday. It looks I'll be buying myself a birthday present, a replacement HD for $75.
- If you have copied text output that contains formatting (colors, highlighting, etc.), please do not enclose it in QUOTE or CODE tags. Just right-click your mouse and choose "Paste Without Formatting" or similar (Paste as plain text).
Leave a comment: