I just installed Kubuntu and whenever I boot up, I always got error message even though the boot process is success (I can access my Kubuntu without problem).
But when I check the error logs using
I got this error:
My laptop is Acer Swift X and I dual booted Kubuntu & Windows 11.
Is it OK if I ignored it? or there's any way to fix the error? Thanks
But when I check the error logs using
journalctl -b -xep err
Nov 30 09:23:23 Swift-X kernel: integrity: Problem loading X.509 certificate -65
Nov 30 09:23:23 Swift-X kernel: integrity: Problem loading X.509 certificate -65
Nov 30 09:23:23 Swift-X kernel:
Nov 30 09:23:23 Swift-X kernel: mt7921e 0000:03:00.0: ASIC revision: 79610010
Nov 30 09:23:24 Swift-X kernel: mt7921e 0000:03:00.0: Firmware init done
Nov 30 09:23:24 Swift-X bluetoothd[801]: Failed to set mode: Blocked through rfkill (0x12)
Nov 30 09:23:31 Swift-X kernel: ntfs3: Unknown parameter 'windows_names'
Nov 30 09:23:31 Swift-X kernel: ntfs3: Unknown parameter 'windows_names'
Nov 30 09:23:33 Swift-X wpa_supplicant[865]: bgscan simple: Failed to enable signal strength monitori>
Nov 30 09:23:23 Swift-X kernel: integrity: Problem loading X.509 certificate -65
Nov 30 09:23:23 Swift-X kernel:
Nov 30 09:23:23 Swift-X kernel: mt7921e 0000:03:00.0: ASIC revision: 79610010
Nov 30 09:23:24 Swift-X kernel: mt7921e 0000:03:00.0: Firmware init done
Nov 30 09:23:24 Swift-X bluetoothd[801]: Failed to set mode: Blocked through rfkill (0x12)
Nov 30 09:23:31 Swift-X kernel: ntfs3: Unknown parameter 'windows_names'
Nov 30 09:23:31 Swift-X kernel: ntfs3: Unknown parameter 'windows_names'
Nov 30 09:23:33 Swift-X wpa_supplicant[865]: bgscan simple: Failed to enable signal strength monitori>
Is it OK if I ignored it? or there's any way to fix the error? Thanks