laptop not charging.

[pnunn]

Steal away.. lol.. My issue hasn't happened as frequently as it was, but still occasionally happens. The only way I've found to fix it is to remove the battery and put it back in (which isn't possible in your case by the sounds of things). It's rare now, but still annoying.

Peter.

[oshunluvr]

Since the OP hasn't come back I'm stealing his thread: My issue is only a little different.

Dell V13 Vostro, original battery (not removable without dis-assembly so I can't test the remove-and-return behavior) and charger.

Kubuntu 12.04
Battery tray says: Charging
/proc/acpi/battery/BAT0/state says: Charged

Behavior is battery does not charge while Kubuntu is running and plugged-in, but holds it's state of charge - does not drain.
When plugged-in and off - battery charges normally.

I searched around a bit and found old threads referencing starting "upower" but this made no difference. Interesting to note, upower -d shows "charging" although the energy/percentage does not climb regardless of the length of time it's plugged in.

This behavior has been going on since the upgrade to 12.04 but I haven't bothered to fix it - I just told my wife to shutdown once in a while to recharge the battery.

On a side-note - the power and battery LEDs are no longer lighting up and I swear the did in the past.

[GreyGeek]

Those readings must be after you've recovered the charging ability by powering down and removing the battery.

BTW, /proc is gradually being phased out in favor of /sys, and the BAT0 data will be/is here:
/sys/bus/acpi/drivers/battery/PNP0C0A:00/power_supply/BAT0/

The command "apci" will fetch the hardware info easily. You can open a Konsole and use

man acpi

to read about the various switches that command uses.

Put your box into suspension and then wake it up and in a Konsole run

acpi -Vi

and post the output here.

The problem may be a need to re-calibrate your battery.

Let me add that you should NOT let your LION battery discharge completely to 0%. That could damage your battery. The video says to charge the battery to 100% and then put it into the sleep mode till it shuts down, then leave it set for an additional 5 hours. Then fully recharge it to 100% before using it.

[pnunn]

Thanks GreyGeek... in line below.

What does

cat /proc/acpi/battery/BAT0/state
present: yes
capacity state: ok
charging state: charged
present rate: 1 mA
remaining capacity: 5600 mAh
present voltage: 12895 mV


cat /proc/acpi/battery/BAT0/info
present: yes
design capacity: 5600 mAh
last full capacity: 3735 mAh
battery technology: rechargeable
design voltage: 11100 mV
design capacity warning: 560 mAh
design capacity low: 169 mAh
cycle count: 0
capacity granularity 1: 56 mAh
capacity granularity 2: 56 mAh
model number: DELL TX28302
serial number: 1257
battery type: LION
OEM info: SMP

show?

Peter

[perspectoff]

(removed after re-reading the OP)

[GreyGeek]

What does

cat /proc/acpi/battery/BAT0/state
cat /proc/acpi/battery/BAT0/info

show?

[pnunn]

Hi folks,

just discovered something new with my laptop running 12.04.

After its been to sleep, the battery does not charge. The battery panel indicator says its changing, but infact it is not. The only way to get it to start again is to power off, remove the battery, put it back in, and all is good until the next suspend.

This is relatively new behaviour, it was working fine during the Beta testing, but I don't know exactly when it started playing up.

Any ideas?

ta

Peter.